The maintenance process of artificial turf is different from that of traditional turf. The concept of "the site needs to rest" is no longer used, but proper maintenance will extend the service life and aesthetic degree of turf
Here are some tips to help you maintain the turf
Keep the site clean and clean when necessary
Make sure there are enough dustbins for the use of sports personnel
Control the frequency of use of the site
Keep adjacent areas free of rubbish, debris, mud, dirt and oil spills
The sign "no smoking, no food" shall be erected on the site
Repair minor damage in time
Do not park the vehicle on the site, especially in hot days, or on wet grass for a long time
If the grassland is used with overload, the site shall be specially arranged with plywood and fiber to protect the turf
Observe maintenance and cleaning procedures
Prohibited acts:
Golf, mobile shooting, javelin, discus throwing and spiked shoes ignition
Fireworks, welding, etc
Use the metal brush in an incorrect way
Load over 3psi (as stated) or 35psi (dynamic)
Improper use of cleaning equipment, methods or materials
High pressure water spray over 300PSI
Vehicles without pneumatic tires
Different from the required sand injection method
Basic requirements:
After the initial installation, it will take at least two weeks to process and stabilize the grass fiber. During this period, sports can be carried out, but we recommend that all heavy equipment and unnecessary traffic vehicles not drive into the playground. In addition, during this period, the cleaning time shall be minimized and not cleaned in hot days
In addition, unlike natural grass, rubber particle filled grassland often needs several weeks of use and weathering to achieve the best sports performance. This period of time requires not only deep weaving of fiber into the artificial grass ground, but also suitable for particle filling to achieve a comfortable and ideal state suitable for long-term sports
Cleaning and decontamination:
Rain is your best cleaner. The rain can gently clean the dust on the grass fiber and the scattered pollutants. Aolin needs to clean the garbage generated in the use of the site in time. It is easy to clean the paper, peanut shell, melon seeds, tape, etc. with a vacuum cleaner in time after use
Stain removal:
In most of the antifouling fibers, polyethylene fiber is well known because most of the stains are caused by moisture, but polyethylene does not absorb moisture. Most of the stains on polyethylene fiber should be cleaned with water or soapy water
1. Use a strong fibre brush to clean up the dross
2. Scrub with soapy water
3. Rinse thoroughly with water where there is soapy water
4. If necessary, dry it with a absorbent towel
Note: don't shoot water with a powerful shotgun over 300 psi, which will damage the grass
Guidelines for the use of sports venues:
Suggestion: it is not allowed to load more than 3psi for a long time, and the load of movement on the surface is not allowed to exceed 35psi. As a continuous use facility, it is allowed to place a limited number of chairs on the site during important activities such as graduation ceremony
Snow and ice will not affect the ground. Usually, they will melt and discharge from the ground by themselves. Try to remove snow as near as possible to the competition time. This can prevent the ground from being cleaned again due to snow again and cold wind freezing when the air is wet. Because it is very difficult to remove ice, it is particularly important to prevent icing.
