The specific pavement steps of landscape greening artificial turf are divided into seven major steps, the construction details are labeling-sand filling-foundation finishing-lawn finishing-laying grass-filling quartz sand-later inspection. The following is a detailed explanation of the pavement requirements and the secrets of pavement for the greening site.
Step 1 of landscape greening artificial turf pavement, marked. Excavate the site to be constructed and mark the excavated site; excavate the site according to the range of the site mark.
Landscape greening artificial turf pavement step two, site drainage design. Dig a ditch with a depth of 100㎜ to allow rainwater to flow out.
Step three of pavement for artificial turf greening site, fill the site with sand. Spread gravel with a height of 7.5㎝ and lime or sand of 5㎝ on the construction site, and spread it evenly around the site. Step four, the foundation of the site. First, check the flatness of the construction site, and sprinkle water on the basis of the leveling of the site; then use a ramming machine to compact the foundation. The purpose of the foundation compaction is to ensure that the site does not have stones protruding from the surface and the foundation should be lower than the horizontal ground ㎝.
Step 5 of artificial turf pavement, artificial turf finishing. Transport the artificial turf into the site and lay it flat on the construction site; then, use a sharp knife to cut off the excess turf. Of course, in order to flatten the lawn, make sure that when cutting, the lawn cutting edge must be straight.
Landscape green pavement step six, lawn pavement. When paving the artificial turf, make sure that the direction of the grass rolls is the same every time. Between the artificial lawn blocks, the pavement should be closely connected, and there should be no large gap distance. At the same time, it is necessary to pay attention to the artificial turf during the pavement process, roll up the edge of the lawn to both sides, and ensure that the surface of the seam cloth is clean.
In addition, the seam cloth should be put straight, and the seam cloth must be coated with special glue for artificial turf. In addition, put the lawns on both sides on the seam cloth, and ensure that the seam edge of the lawn is on the center line of the seam cloth; if the artificial turf is stuck to the seam cloth during the pavement process, you need to use your fingers to The grass on both sides of the seam was pulled straight out.
Construction Step 7: The secret of the beautiful results of landscape artificial turf pavement-filled with quartz sand or rubber particles. This is a landscape green lawn. If the greening site needs to be filled with quartz sand and rubber particles, the purpose of filling quartz sand and rubber particles is to fix the artificial turf on the ground; Fix the 50㎝ place with 15㎜ nails.
For landscape green lawns, it is recommended to fill 6kg of quartz sand per square meter of artificial turf. If a more comfortable effect is required, 1-3Kg of rubber particles per square meter of artificial turf can be filled, which is much less than that of football field artificial turf, but the effect well. After the artificial turf filler is filled, comb the grass with a rake to make the direction of the artificial grass consistent, and improve the overall pavement aesthetic effect.
