1. After the artificial turf arrives at the site, do not rush to cut, spread out the turf completely, leave it in the air for at least 24 hours, release the stress generated in the production and transportation of the artificial turf completely, and make the turf adapt to the heat expansion and cold contraction of the new environment, so as to avoid too large joint after pavement.
2. When cutting artificial turf, don't try to cut it with a knife. It's better to cut it a little bit larger, then a little bit opposite and trimming, in case of too large gap after cutting. Only slow work can produce fine work.
3. When cutting artificial turf, it is easier to turn it up and cut it from the back.
4. When brushing the glue, be careful not to apply the glue on the grass wire, otherwise the joint will be obvious.
5. There is no need to brush glue between the joint belt and the cement floor to save glue. At the same time, the suspension state of the lawn is conducive to drainage and release the displacement caused by thermal expansion and contraction in use.
6. When cutting, it is necessary to ensure that the direction of straw lodging in the whole site is the same, otherwise there will be obvious color difference.
