First, the maintenance of artificial small plants and artificial flowers, artificial leaves
For example, after some small plants are placed for a long time, the plants may be covered with a layer of dust, and the leaves may fall off slightly. You only need to remove the dust-contaminated leaves and rinse them with clean water, dry them, and then insert them back into place. The pole can be wiped clean with a wet towel, and the fallen leaves can be coated with hot melt glue on the protruding interface, and then inserted back to the tree pole.
Second, the maintenance and maintenance of large artificial plant trees
1. The tree body may be damaged or worn out if it is left for too long. We use the original tree body (usually glass fiber reinforced plastic) material, take a small amount of it to make up the damaged area, and then use a brush to brush the lines, and wait for the ingredients to dry. , Paint the corresponding color.
2. If the branch is broken by strong wind or other reasons, we need to find the original broken branch, use a machete to trim the bottom to match the previously inserted tree hole, then insert it into the tree hole, and smear the outer edge with FRP material to cover the interface. Then use some small nails to fix the tree body and pole.
In the maintenance of branches, it is recommended not to allow pedestrians to pull branches and leaves randomly. For guests with strong curiosity, we can come forward to stop or put up a warning.
3. For small branches falling, we can use a nail gun to re-fix the small branches on the tree pole, and use a larger nail to nail it with a hammer for reinforcement. For the fallen leaves, you need to use a drill to make holes on the branches, then apply hot melt glue to the bottom of the leaves and insert them into the corresponding holes.
4. If the color of the tree body is fading, we first need to see the color of the original tree clearly, analyze how the color of the original tree is modulated, and then color step by step, and finally modulate the original color of the tree body layer by layer.
5. If there is a problem of swinging up and down or left and right on some parts of the branch, you need to find the active node first, and then fix the active node with iron nails.
ZheJiang Ruopei Arts & Crafts Co., Ltd
Tel: 86-579-8597-7190
Mobile: 86-19905898261
Fax: 86-579-8597-7190
Email: tiffany@ruopeichina.com
Add: No. 10,One Street, Wuhua Road, Heyetang Industrial Zone, Yiwu, Zhejiang, China
